Getting Started; Cooling; Set Up An Ashly Power Amplifier - Ashly ne8250c User Manual

Ashly Amplifier User Guide (Rev. B, Ver. 0)

2.0 Getting started

Important: Before installation, unplug the amplifier, and turn down the channel attenuators
on the front panel.
This chapter discusses the following topics:

Cooling

l

Set up an Ashly Power Amplifier

l
2.1 Cooling
Do not block any of the amplifier ventilation vents. When using an equipment rack, mount the
units directly on top of each other. Do not block rear, front, or side air vents. The side walls of
the rack should be a minimum of one inch (2.5cm) away from the amplifier sides, and the back
of the rack should be open.
2.2 Set up an Ashly Power Amplifier
Figure 3, "Ashly Power Amplifier rear panel" below shows the Ashly Power Amplifier's rear
panel:
To set up an Ashly Power Amplifier, follow these steps:
1. Use the first or second port and a CAT5 cable to connect to the ACENet switch. Do not
connect both.
2. Connect the 10/100 Ethernet port to the ACENet switch.
3. Connect the alternating current (AC) power cord.
Copyright © 2019 Advanced Simulation Technology inc.
Figure 3: Ashly Power Amplifier rear panel
3