Step 4: Tuning Your Tv To The Vcr - Sony SLV-ED515PS Operating Instructions Manual

Step 4
Tuning your TV to the VCR
If you have connected your VCR to the TV using the audio/video cable, skip
this step.
1
ON/STANDBY
2
RF CHANNEL
3
8
Getting Started
?/1 ON/STANDBY
RF CHANNEL
Press ?/1 ON/STANDBY to turn on the VCR.
Press RF CHANNEL on the VCR.
The factory-preset RF channel flashes in the display window for
about three seconds. (RF32 is for SLV-ED818ME/SG and ED616ME/
MJ/SG and RF51 is for SLV-ED915PS/TH, ED817TH/ED815PS and
ED515PS)
Press RF CHANNEL again while the RF channel is flashing.
The VCR signal is output through this channel to the TV.
Turn on your TV and select a programme position for the VCR picture.
This channel will now be referred to as the video channel.
Some TVs reserve a programme position, such as "0", for a VCR. In
this case, select the reserved programme position for the VCR
picture. Refer to your TV's instruction manual for details.
PROGRAM +/–
e.g. SLV-ED915PS/TH
SP
APC