Displaying The Pull Down Time Code; Superimposition Of Character Information; Chara Super/H-Pos/V-Pos) - Sony HDW-F500 Operation Manual

4-3 TC Menu
4-3-10 Displaying the Pull Down
Time Code (when HKDV-507 is
installed)
To display the pull down time code, follow the steps
below.
1
Press the TC button, then press the ALT button.
2
1
2
Press the [F5] (PDTC DISP) key to select
on: Displays the pull down time code.
off: Does not display the pull down time code.
4-28
Chapter 4 Menu Settings
4-3-11 Superimposition of
Character Information (PD
CHARA/CHARA SUPER/H-POS/
V-POS)
To superimpose the characters representing time code
data and operation mode information on the output
signals, use the [F4] (PD CHARA) and [F6] (CHARA
SUPER) buttons.
Button Setting Connector to which the
ALT/[F4] on
ALT/[F6] on
Contents of superimposed data
on
" ".
T C R . 2 3
S H U T T L E
Note
The example above shows the factory-set contents of
data.
By changing the 626.DISPLAY INFORMATION
select setting in the VTR SETUP menu, different types
of information can also be displayed on the second
line.
characters are superimposed
PULL DOWN OUT connector (on two
connectors)
• HD SDI MONITOR connector
• COMPOSITE (SUPER) connector
of D CONV. OUT(OPTION)
• 3(SUPER) of connector D CONV. SDI
OUT(OPTION)
1 Types of time data
Time data
2 Drop frame mark of the time
code reader
3 Drop frame mark of the time
code generator
4 Field mark of the
VITC data
: 5 9 . 4 0 . 1 8 *
S T I L L
5 Control VTR indication
Contents of superimposed data