Sony GV-HD700 Operating Manual page 14

Step 2: Preparing the power supply (Continued)
To remove the battery pack
Set the POWER switch to OFF (CHG).
Push and hold the vBATT RELEASE
button and remove the battery pack.
L series:
b Notes
• When you remove the battery pack or
disconnect the AC Adaptor, make sure that the
POWER/CHARGE lamp is turned off.
To use the "InfoLITHIUM" battery
pack M series (optional)
To attach:
Attach the battery pack by holding the
center part (1) and sliding it in the
direction of the arrow (2) until it clicks.
Make sure that the battery pack is not
inclined and is locked to the VCR securely.
14
vBATT
RELEASE
button
To remove:
When storing the battery pack
Fully discharge the battery pack before
storing it for an extended period (see page
79 for details of storage).
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISPLAY/BATT INFO.
After a while, the approximate available
playback time and battery information
appear for about 7 seconds. You can view
the battery information for up to 20 seconds
by pressing DISPLAY/BATT INFO again,
while the information is displayed.
Remaining battery (approx.)
Available playback time (approx.)
vBATT
RELEASE
button