Sony UP-D2600S Service Manual page 77

<Caution on CheckD25.exe> (UP-D2600 only)
. Message "Any Port's not connected" is displayed when UP-D2600 is connected to start CheckD25.exe.
In this case, set OK. After CheckD25.exe is started, the UP-D2600 can be used by selecting a port.
. This service software operates using the bi-directional communication function of a parallel interface.
To use the printer port of a personal computer, set it to the bi-directional communication enable mode
(Compatible-Nibble or ECP mode). For the setting, refer to the Operation Manual of a personal
computer. (The default value of a personal computer is usually set to the bi-directional communication
enable mode.)
. In the Compatible-Nibble mode, any communication cannot be performed when a printer is in the error
state. The printer operates only in the state where no error occurs (all LEDs on the front panel are off).
. In the ECP mode, a printer can be used even in the state where an error occurs. The EPC mode can be
used by setting the printer port of a personal computer to EPC mode. (In some personal computers, the
ECP mode may not operate. For more details, refer to the Operation Manual of a personal computer.)
1. QTY Error Read
Click to display the current status of the printer.
Displays the total number of printed sheets, number of printed sheets after replacement of head, and
error codes.
2. DRAM Check
Self check of image an data bus is performed. (Check25.exe only)
3. BUS Check
Self check of a CPU data bus is performed. (Check25.exe only)
4. Print
Print button.
5. Error Code
Information on mechanical deck errors
Displays the latest error information during mechanical operations. The contents correspond to the
NG_CODE1 data.
6. Service Command
Writes and reads service commands to the printer.
Use the service commands to perform electrical and mechanical adjustments.
Contents of service commands are the same as using both LED display and S201 through S206 on the
IF-787 and IF-788 boards.
m
. Do not perform writing operations other than the writing of the service commands described in this
manual, or errors may occur in the worst case.
. Do not perform writing operation during printing.
7. Port
Used to set the SCSI ID used on the printer. (For CheckS25.exe)
Used to set the printer port used on the personal computer.
UP-D2600/V1(E)
3-3