Table of Contents
Advertisement
Location and Function of Parts and Controls
For details, refer to the pages given in parentheses.
Front
1
POWER switch (18)
Press to switch the unit on or off. The POWER
lamp lights green when the power is on.
2
Top cover
Do not open this top cover. Only for service
personnel.
3
PRINT indicator (18, 24)
Lights while printing.
Blinks while the printer is receiving data.
4
ALARM indicator (18, 24)
Lights in case of paper jamming or occurrence
of any other problem.
8
Introduction
5
RIBBON indicator (18, 24)
Lights when a problem for ink ribbon
cartridge occurs.
6
PAPER indicator (18, 24)
Lights when a problem for paper occurs.
The printer allows you to check the printer
operating condition according to the lighting
conditions of the PRINT indicator, ALARM
indicator, PAPER indicator and RIBBON
indicator.
For details, see "Indicators on the Front Panel"
on page 24.
7
Front panel
Pull the top on the front door toward you to
open it.
Opening the front panel reveals the ink ribbon
cartridge, paper tray and paper cover.
When the front panel is open
A
B
C
Rear
1
Parallel interface connector (Amphenol 36-
pin) (12)
Used to connect a Windows computer via the
parallel interface (IEEE-1284), using the
parallel data cable (not supplied).
Refer to "Important safeguard/notices for use
in the medical environments" on page 2.
A Ink ribbon cartridge (11, 13)
Insert the ink ribbon cartridge.
B Paper cover (11)
Paper is ejected onto this cover.
C Paper tray (11, 16)
Load paper into this tray.
8
STOP button (19)
Press to stop printing midway.
9
PRINT button (18)
Press to print the image stored in the memory
of the printer again.
~
AC IN
2
Equipotential ground terminal
Used to connect to the equipotential plug to
bring the various parts of a system to the same
potential.
Refer to "Important safeguards/notices for use
in the medical environments" on page 2.
3
-AC IN connector
Used to connect the printer to a wall outlet
with the supplied power cord.
Introduction
9
Advertisement
Table of Contents
