Programming A Series Of Commands To The System Control Buttons - Sony RM-VL900 Operating Instructions (primary manual) Operating Instructions Manual

Executing a Series of Commands
— System Control Function
(continued)
Programming a series of
commands to the SYSTEM
CONTROL buttons
Example: To program the
procedure for the video to the
SYSTEM CONTROL 2 button
1
Press S (set).
All Component Select buttons
flash.
24
If a series of commands is
already programmed on
that button
(At the factory, the SYSTEM
CONTROL 1 button is preset
with the System Power-Off
function for Sony components,
and the SYSTEM CONTROL 3
button is factory preset with
standard Power-On command
for nearly all Sony
components.)
To program a new series of
operations, clear the program
first (see page 26).
2
Press SYSTEM
CONTROL 2.
All Component Select buttons
light up.
3
Press the Component Select
button for the component
to operate.
The Component button lights
up when you press it, and
turns off when you release it.