Operating Your Components With The Remote Commander - Sony RM-AV2500 Operating Instructions (primary manual) Operating Instructions Manual

Operating Your
Components with the
Remote Commander
When you operate a non-Sony
component, make sure you set the
component code first (page 8).
1
Example: To play a CD player
1
Press the desired Component
Select button.
The Commander comes on and the
keys for operating the selected
component are displayed.
2
Press the desired key in the
touch-key display.
When the remote control signal is
sent,
You may also use the VOLUME +/–
buttons, the MUTING button and the
CHANNEL +/– buttons if necessary.
See "Table of Preset Functions" (page
2
59) for the functions of keys and
buttons for each component.
3
When you are done using the
Commander, press
COMMANDER OFF to power off
the Commander.
3
Note
The remote control signals may be different for
some components or functions. In this case,
program the remote control signals with the
learning function (page 15). Note, however,
that components and functions that do not
support the remote control of infrared signals
will not work with this Commander.
is shown on the display.
Continued
13