Adding A Command That Is Required When Selecting A Component - Sony RM-AV2500 Operating Instructions (primary manual) Operating Instructions Manual

Adding an Extra Function to the
Component Select Buttons
(continued)
Adding a command that is
required when selecting a
component
In addition to the original function of
selecting the operating keys and buttons
of the desired component, the
Component Select button can have
another remote control signal by
"learning."
For example, if you always have to
change input select of the amplifier to CD
when listening to the CD player, program
the signal of "changing the amplifier's
input select" to the CD button of this
Commander. Then whenever you press
the CD button, it automatically works as
the original CD Component Select button
and changes also the amplifier input
select to CD. (In this case, the amplifier
should be turned on first.)
Note
Some specific remote control signals may not
be learned.
MENU
A
TV
3
AMP
32
VOLUME CHANNEL
OK
EXIT
MUTING RECALL
SYSTEM CONTROL
LIGHT COMMANDER OFF
B C MORE
CBL SAT DVR VCR M1
M2
CD MD TAPE DVD
Example: To program the input
select signal of your amplifier to
the CD button
1
Place the RM-AV2500 head to
head with your component's
remote control.
Remote control of
your component
about 2 – 4 inches
(5 – 10 cm) away
2
While pressing COMMANDER
OFF, press CHANNEL + and
VOLUME +.
Learnable SYSTEM CONTROL keys
and number keys flash in the display
panel.
2
Note
The name of a Component Select button for
which a signal has already been learned
stays lit. If you want to program a new
5 signal for that button by learning, clear the
learned signal first (page 33).
RM-AV2500