Operating Your Components With The Remote Commander - Sony RM-VL610T Operating Instructions Manual

5
Check if the code number works by
following the instructions on page 9.
Notes
• If you do not input anything into the Commander within
20 seconds between each step, the setup procedure will
be cancelled. To set the code, start over from the
beginning.
• If you press any button other than PROG +/– and 1
while setting the component code, all code numbers will
be lost, and the setup procedure will be cancelled. Start
over from the beginning.
To cancel setup, press SET.
Operating Your Components
with the Remote Commander
When you operate a non-Sony component, make
sure you set the component code first (page 8).
Example: To operate a video cassette recorder
1
Press the desired Component Select button.
The Component Select button lights up when
you press it, and turns off when you release it.
2
Press any Player Control button.
See "Table of Preset Functions" (page 30) for the
functions of buttons for each component.
Note
The remote control signals may be different for some
components or functions. In this case, programme the
remote control signals with the Learning function (page
12). Note, however, that components and functions that do
not support the remote control of infrared signals will not
work with this Commander.
11
Continued