Table of Contents
Advertisement
d
Pull up the supplemental spool pin and set it in the up
position. Place the additional spool of thread on the
supplemental spool pin, so that the thread unwinds
from the front. Push the spool cap onto the spool pin as
far as possible to secure the thread spool.
a
1 Spool cap
2 Spool pin
3 Spool of thread
e
Hold the thread from the spool with both hands, and
place the thread in the thread guide.
*
Do not place the thread in the pretension disks.
1 Thread guide
f
While holding the thread from the spool, pull the
thread through the lower notch in the thread guide
plate, then through the upper notch. Hold the end of
the thread with your left hand, and then guide the
thread through the groove, following the arrows in the
illustration.
g
Continue threading; however, do not pass the thread in
the needle bar thread guide "6" on the needle bar.
Thread the needle on the right side.
1 Needle bar thread guide
h
Press
to unlock all keys and buttons.
i
Select a stitch pattern.
*
Refer to "Basic Sewing" on page 56 for selecting a
stitch pattern.
*
Refer to "STITCH SETTING CHART" on page 190
for the proper stitch to use with presser foot "J".
c
a
a
j
Press
to select the twin needle mode.
1
1 Single needle/twin needle position setting display
appears.
CAUTION
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
k
Start sewing.
Sample of Twin Needle Sewing
UPPER THREADING
1
45
Advertisement
Table of Contents
