Connecting Additional Equipment - Sony KV-27FA210 Instructions: TV stand (primary manual) Operating Instructions Manual

Connecting Additional Equipment

Connecting a TV and VCR
1
From
cable/antenna
1
Connect the coaxial cable from your TV antenna or cable service to the IN jack on your
VCR.
2
Connect a coaxial cable (not supplied) from the OUT jack on your VCR to the VHF/UHF
jack on the TV.
Optional connection
❏
If your VCR is equipped with video outputs, you can get better picture quality by
connecting audio/video cables (not supplied) from AUDIO/VIDEO OUT on your VCR to
AUDIO/VIDEO IN on your TV.
❏
For better picture quality, use S VIDEO instead of the yellow video cable. S VIDEO does
not provide sound, so you still must connect the audio cables.
Using your TV with this connection
This connection allows you to do the following:
❏
Program your Sony remote control to operate your VCR (see page 5).
❏
To activate your remote, press
remote control, then use the Channel Fix feature to set your TV to channel 3 or 4 (see page 29).
❏
Press repeatedly to switch between VCR input (VIDEO input) and VHF/UHF
(local channels).
2
VCR
Optional connection
to operate your VCR. To do this, first program your
Connecting Your TV
Rear of TV
1 3 4 5 AUDIO OUT
(VAR/FIX)
Y
S VIDEO
P
B
P
R
VIDEO
L
L
(MONO) (MONO)
R R
Video (yellow)
Audio L (white)
Audio R (red)
13