Boiler Location & Clearances - Bosch Worcester GREENSTAR CDi Series Instruction Manual

SERVICING
C L E A R A N C E S ~ -
-
Using 1 00 mm flue kit
-1112 mm
Using 1 25 mm flue kit
-1152 mm
'20mm
' to removable door
600mm
' front clearance
' for service
+30mn
above elbow
' 200 mm '
5mm
~ O R C E S T E R
Bosch Group
INSTALLATION & SERVICING INSTRUCTIONS FOR WORCESTER BOSCH GREENSTAR 25CDV30CDV37CDci42CD•
6 720 613 700a (2006/11)
BOILER LOCATION
&
CLEARANCES
This boiler is only suitable for installing internally
within a property at a suitable location onto a
fixed, rigid non-combustible surface at least the
same size as the boiler and capable of support-
ing the boiler weight.
COMPARTMENTS:
Follow the requirements of BS6798 and
BS5440 Part 2 and note:
Minimum clearances must be maintained
• An access door is required to install, service
and maintain the boiler and any ancillary
equipment.
• If fitting the boiler into an airing cupboard
use a non-combustible perforated material
(maximum hole sizes of 13mm) to separate
the boiler from the airing space.
BOILER CLEARANCES:
The diagram opposite shows the m1n1mu
space required to install and service the boiler.
VENTILATION
This is a room sealed appliance and does not
require any air for combustion from inside the
property. If the appliance is fitted into a cup-
board or a compartment is built around the
appliance after installation, then the compart-
ment must be separated from the boiler space
by a perforated non-combustible partition as
described in BS 6798.
Notwithstanding the requirements of BS 6798
and BS 5440 there is no need for ventilation
openings to be provided in the compartment
because of the low heat loss from the appliance
casing, if the clearances shown are maintained.
Do not operate the appliance if the flue terminal
fitted on the outside wall or roof is obstructed
or damaged.
BOILER LOCATION & CLEARANCES