General Information; Hazard Definitions - Beckett SF Series Manual

General Information

Hazard Definitions:

Indicates a hazardous situation
that, if not avoided, will result in
death or serious injury.
Indicates a hazardous situation
that, if not avoided, could result
in death or serious injury.
Indicates a hazardous situation
that, if not avoided, could result
in minor or moderate injury.
Used to address practices not
related to physical injury.
Safety instructions signs
indicate specific safety-related
instructions or procedures.
This manual contains information that applies to both SM and SF burners. These burners may
appear to be basically identical, but there are differences in design and performance. Please
review the comparison chart below:
Feature
Firing Rate Range
Motor
Fuel Pump Capacity
UL Air Tube Combinations
Blocking Oil Solenoid Valve
Primary Control Lockout Timing
Primary Control
Option to ship less Primary Control
for Pressure Washer Industry
Figure 1 – Burner Label Location
SF/SM Burner Manual
Contact a professional, qualified service agency for the
installation, adjustment and service of your oil heating
system. This work requires technical training, trade
experience, licensing or certification in some states and
the proper use of special combustion test instruments.
Please carefully read and comply with the following
instructions:
Never store or use gasoline or other flammable
y
liquids or vapors near this burner or appliance.
Never attempt to burn garbage or refuse in this
y
appliance.
Never attempt to light the burner/appliance by
y
throwing burning material into the appliance.
Never attempt to burn any fuel not specified and
y
approved for use in this burner.
Never restrict the air inlet openings to the burner or
y
the combustion air ventilation openings in the room.
SM
1.25 to 3.00 gph
1/5 HP
3 gph (standard)
See Table 2
Optional
15 to 45 seconds (optional)
Beckett GeniSys 7575P
Yes
(Model 7575P Primary Control with "valve-on delay" and
"motor-off delay" required in final installation.)
Section: GENERAL INFORMATION
Owner's Responsibility
Incorrect installation, adjustment,
and use of this burner could result
in severe personal injury, death, or
substantial property damage from fire,
carbon monoxide poisoning, soot or
explosion.
1.25 to 5.50 gph
1/4 HP
7 gph (standard)
See Table 2
Required above 3 gph
15 seconds maximum
Beckett GeniSys 7505 or 7575
No
SF
3