Reassembly Procedure; Returning A Noise Source For Calibration - Agilent Technologies N4000A Operating And Service Manual

Figure 1-17
Step 1. At the rear of the noise source, insert the blade of a screwdriver between
Step 2. Pry alternately at both sides of the connector (see Figure 1-17) until the
Step 1. Replace the magnetic shields and plastic shells as shown in Figure 1-15.
Step 2. Snap the plastic shells together.
Removing the Smart Noise Source Plastic Shell
Disassemble the Smart Noise Source by performing the following steps.
the plastic shells (see Figure 1-17). To prevent damage to the shells, use
a screwdriver blade as wide as the slot between the two shells.
plastic shells are apart. Remove the shells and the magnetic shields.

Reassembly Procedure

Returning a Noise Source for Calibration

When returning a Smart Noise Source to Agilent Technologies for
calibration send it to your nearest Sales and Service Office. These are
listed in Table 1-8.
Chapter 1
General Information
Service
31