Ricoh P800 User Manual page 28
Hide thumbs
Also See for P800:
- Setup manual (32 pages) ,
- Operating instructions manual (12 pages) ,
- Field service manual (1110 pages)
Table of Contents
Advertisement
1. Getting Started
Check that the interface board is firmly connected to the controller board.
5.
Tighten the two screws to secure the interface board.
6.
Connect the device server option to the machine.
For details, see the Setup Guide provided with the device server option.
Configuring settings
After installing and connecting the device server option to the machine, configure the machine
settings.
• When using the device server option, set [Engy Sv Md to Dsbl Prt Srv] to [Disable Mode] to prevent
the machine from entering Energy Saver mode. Otherwise, the device server option loses
communication with the network while the machine is in Energy Saver mode, and the machine
cannot receive print jobs.
1.
Press the [Menu] key.
2.
Select [System], and then press the [OK] key.
3.
Select [Engy Sv Md to Dsbl Prt Srv], and then press the [OK] key.
4.
Select [Disable Mode], and then press the [OK] key.
26
EBS152
EBS175
Advertisement
Table of Contents
