Sony BDV-IS1000 Operating Instructions Manual page 124

Sound
Symptom
There is no sound.
No sound is output from the
HDMI OUT jack.
The Super Audio CD sound of a
component that is connected to
the HDMI1 or HDMI2 jack is
not output.
The left and right sounds are
unbalanced or reversed.
There is no sound from the
subwoofer.
Severe hum or noise is heard.
The sound loses stereo effect
when you play a CD.
The surround effect is difficult to
hear when you are playing a
sound track of Dolby Digital,
DTS, or MPEG audio.
The sound comes from the center
speaker only.
No sound is heard from the
center speaker.
No sound or only a very low-
level sound is heard from the
surround speakers.
124
US
Remedy
• The speaker cord is not connected securely.
• Press MUTING on the remote if "MUTING ON" is displayed in the front panel
display.
• The system is in pause mode. Press H to return to normal play mode.
• Fast forward or fast reverse is performed. Press H to return to normal play
mode.
• Check the speaker settings (page 100).
• The HDMI OUT jack is connected to a DVI (Digital Visual Interface) device
(DVI (Digital Visual Interface) jacks do not accept audio signals).
• Try the following: 1 Turn the system off and on again. 2 Turn the connected
component off and on again. 3 Disconnect and then connect the HDMI cable
again.
• Set [Audio (HDMI)] in [HDMI Settings] to [TV+AMP] (page 115).
• HDMI1 and HDMI2 does not accept an audio format that contains copy
protection (page 133). Connect the analog audio output of the component to the
SAT/CABLE IN (AUDIO R/L) or TV (AUDIO IN R/L) jacks of the unit.
• Check that the speakers and components are connected correctly and securely.
• Check the speaker connections and settings (pages 45, 100).
• Select "
A.F.D. STD" for the decoding mode (page 77).
• Check that the speakers and components are connected securely.
• Check that the connecting cords are away from a transformer or motor, and at
least 3 meters (10 ft) away from your TV set or a fluorescent light.
• Move your TV away from the audio components.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with
alcohol.
• Clean the disc.
• Select stereo sound by pressing AUDIO
• Make sure the unit is connected properly.
• Make sure the decoding mode setting
• Check the speaker connections and settings (pages 45, 100).
• Depending on the BD/DVD, the output signal may not be the entire 5.1 channel.
It may be monaural or stereo even if the sound track is recorded in Dolby
Digital or MPEG audio format.
• Depending on the disc, the sound may come from the center speaker only.
• Check the speaker connections and settings (pages 45, 100).
• Make sure the decoding mode setting
• Depending on the source, the effect of the center speaker may be less
noticeable.
• A 2 channel source is being played.
• Check the speaker connections and settings (pages 45, 100).
• Make sure the decoding mode setting
• Depending on the source, the effect of the surround speakers may be less
noticeable.
• Check the wireless setting (page 58).
• A 2 channel source is being played.
.
(page 81)
.
(page 77)
.
(page 77)
.
(page 77)