Table of Contents
Advertisement
Troubleshooting (continued)
Recording cannot be done.
• Check that the components are connected
correctly.
• Select the source component with FUNCTION
control.
• When recording from a digital component, make
sure the INPUT MODE is set to ANALOG 2CH
FIXED (page 42) before recording with a
component connected to the analog MD/DAT or
TAPE terminals.
• When recording from a digital component, make
sure the INPUT MODE is set to COAXIAL
FIXED or OPTICAL FIXED (page 42) before
recording with the component connected to the
DIGITAL MD/DAT OUT terminals.
• Set "D.POWER" to "ALWAYS ON" when
ANALOG DIRECT is selected, for the digital
audio signal is not output in "AUTO OFF"
setting.
To connect an LD player via an RF demodulator.
• Connect the LD player to the RF demodulator,
then connect the RF demodulator's optical or
coaxial digital output to the receiver's DVD/LD
OPTICAL IN or COAXIAL jack. When making
this connection, be sure to set INPUT MODE
manually (page 42). The receiver may not
operate correctly if INPUT MODE is set to
AUTO 2CH.
For details on DOLBY DIGITAL RF hookups,
see the operating instructions supplied with your
RF demodulator.
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied) to
connect the receiver to an outdoor FM antenna as
shown below. If you connect the receiver to an
outdoor antenna, ground it against lightning. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
Outdoor FM antenna
ANTENNA
GB
66
Receiver
75
COAXIAL
FM
U
AM
Ground wire
(not supplied)
To ground
Radio stations cannot be tuned in.
• Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
• The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
• Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning).
• No stations have been preset or the preset stations
have been cleared (when tuning by scanning preset
stations). Preset the stations (page 28).
• Press DISPLAY so that the frequency appears in
the display.
RDS does not work.*
• Make sure that you're tuned to an FM RDS station.
• Select a stronger FM station.
The RDS information that you want does not
appear.*
• Contact the radio station and find out whether or
not they actually provide the service in question. If
so, the service may be temporarily out of order.
There is no picture or an unclear picture appears
on the TV screen or monitor.
• Select the appropriate function on the receiver.
• Set your TV to the appropriate input mode.
• Move your TV away from the audio components.
Remote control
The remote does not function.
• Point the remote at the remote sensor on the
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• If the receiver's COMMAND MODE and the
remote's COMMAND MODE do not match,
transmission is not possible between the remote
and the receiver (page 49).
• Make sure you select the correct function on the
remote.
• When you operate a programmed non-Sony
component, the remote may not function
properly depending on the model and the make
of the component.
Reference sections for clearing the memory
To clear
All memorized settings
Customized sound fields
* Models of area code CEL only.
See
page 19
page 45
Hide quick links:
Advertisement
Table of Contents
