Invacare Bora Series User Manual page 27

Speed limiter
The speed limit reacts in different ways, depending
on the mobility device's configuration.
• Either the lifter is fitted with sensors which
reduce the mobility device's speed as soon as
the lifter is raised above a certain point.
• Or if the speed limit is activated, a reduced drive
level (forced profile) is set automatically. Refer
to the remote manual for more information.
• The speed reduction takes place to guarantee
the tipping stability of the mobility device
and to avoid personal risk and damage to the
mobility device.
• To reapply normal speed, lower the lifter down
until the forced profile or the speed reduction
switches off.
• If the mobility device is fitted with a chin
control, it reacts different to forced profile.
Refer to the manual of the chin control for
more information.
CAUTION!
Risk of tipping, if the speed limiter sensors fail
when the lifter is raised
– If you find that the speed reduction function is
not working when the lifter is raised, do not
drive with the lifter raised and immediately
contact an authorized Invacare provider.
1528224-Y
Limit switch
• If the lifter is raised above a certain point you
can adjust the seat and backrest angles only at
a combined total of max. 15° to ensure a safe
driving behaviour. The set-up allows full tilt and
backrest adjustment when the lifter is down.
In case the tilt and backrest angle exceed 15°
(e.g. 10° tilt and 10° backrest recliner) the lifter
function is disabled.
Components
27