Entering Mission Critical Geofence; Exiting Mission Critical Geofence - Motorola SRX 2200 Model 3.5 User Manual

English

Entering Mission Critical Geofence

When the radio enters the predefined Geofence area, the
radio displays <Geofence Alias> with intelligent backlight
and the user hears a Voice Announcement. Zone and
channel alias of the Geofence area is displayed. If the radio
is set to manual, the user can choose either to proceed
with zone and channel change or cancel the change.
The radio then connects to the designated talkgroup. The
radio displays the talkgroup alias and dynamic regroup
tone sounds. The transmit power level changes and the
radio shows a direct text message content without any user
operation.
166
NOTICE:
Depending on how your radio is programmed, you
may or may not be alerted by Voice Announcement
(VA), TMS display, Intelligent Backlight, and the
Transmit Power Level. The user will be alerted only
if these indicators are configured in the radio. The
VA can be programmed to alert continuously or
momentarily.
If Site Selectable Alert (SSA) is enabled, the radio
mutes any alert that is received when entering the
Geofence area and unmutes when exiting.

Exiting Mission Critical Geofence

When the radio exits the Geofence area, the radio reverts
to the original transmit power level, intelligent lighting,
channel or newly assigned talkgroup. Voice announcement
is cancelled or the user hears a pre-programmed VA tone.