System Drivers - HP Elite 7000 Disassembly Instructions Manual

1.3 Remove the Graphic card from the system board(see Figure 8-11)
a) Loose the screw that secure PCI card with chassis
b) Remove the metal baffle
c) Pull the switch of the PCI_E slot
d) Remove the Graphic card from the slot
1.4 Remove the system fan.(see Figure 12&13 below)
a) Remove the cables from mainboard.
b) Loose the screws and remove the system fan from chassis.
1.5 Remove the processor from the system board: (see Figure 14-18 below)
a) Remove the processor fan cable from the board
b) Loosen the screws that secures the CPU fan to the system board.
c) Lift the heat sink from atop the processor and set it on its side to keep from contaminating the work area with thermal
grease.
d) Rotate the handle and lift the processor from the socket.
1.6 Remove the Memery.(see Figure 19&20 below)
a) push the two handles of the DIMM slot
b) Lift the memery from the DIMM slot
1.7 Remove the system board: (see Figure 21-&22 below)
a) Remove the screws that secure the system board to the chassis .
b) Lift the system board towards then remove it.
2. BATTERY
2.1 Release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. Then the
battery pops up, lift it out.(see Figure 23 below).

3. SYSTEM DRIVERS

3.1 Remove the HDD.(see Figure 24-30 below)
EL-MF877-00 Page 3
Template Revision B
PSG instructions for this template are available at EL-MF877-01