Safety; General Warning; Mattresses; Labels And Symbols On The Product - Invacare SB 755 Service Manual

2 Safety

2.1 General warning

WARNING!
Risk of injury
There is a risk of entrapment of fingers in the
bed moving parts.
– Pay attention to your fingers.
IMPORTANT!
– Make sure that there is nothing under, over,
or near the bed that can limit the movement
of the bed or the mattress support, such as
furniture, window frames and storage boxes.
– Do not roll over the mains cable.
– Do not bring mains cable into moving parts.
– Disconnect the plug from the mains before
moving the bed.
– Make sure that no cables (mains or from
other equipment) are jammed or damaged,
when the bed is used.
– The bed must not be placed close to a direct
heat source (dire place, radiator etc) and not
in direct sunlight.

2.2 Mattresses

WARNING!
Safety aspects regarding combination of side
rails and mattresses:
To get the highest possible safety level, when
using side rails on the bed, the minimum and
maximum measures for mattresses, must be
respected.
– For correct mattress measures see mattress
table in chapter 6 Technical Data, page 23.
WARNING!
Risk of entrapment and/or suffocation
– The user could get trapped and/or suffocate,
if the horizontal space, between the mattress
side and the inside of the side rail, is too big.
Follow the minimum width (and length) of
mattresses in combination with a side rail,
as stated in the mattress table in chapter 6
Technical Data, page 23 .
– Be aware that using very thick or soft
mattresses (low density), or a combination of
these, increases the risk.
1577126-H
WARNING!
Risk of falling
The user can fall over the edge and get seriously
injured, if the vertical distance A between the
top of the mattress and the edge of the side
rail/bed end, is too short. See image above.
– Always keep a minimum distance A of 22 cm.
– Follow the maximum mattress height in
combination with the side rail as stated in the
mattress table in chapter 6 Technical Data,
page 23.

2.3 Labels and symbols on the product

2.3.1 Product label

Invacare Rea AB
Växjövägen 303
34375 Diö - Sweden
XXXXXX XXXXX_XX
XXXXXXXXXXXXX
The product label is placed on the frame of the bed and
contains the main product information, including technical
data.
Symbols
Serial Number
Reference Number
Manufacturer Address
Manufacturing Date
Max. User Weight
Max. Safe Working Load
CLASS II equipment
Type B Applied Part
WEEE conform
This product complies with Directive
93/42/EEC concerning medical devices. The
launch date of this product is stated in the CE
declaration of conformity.
Safety
A
EN 60601-2-52
YYYY - MM
HMI: 79007
5