Receiving in the Scanning Mode
Band Scanning
The receiver divides its frequency range (25.0 MHz to
1300.0 MHz) into 17 bands. Band Scanning scans one of
these bands step by step.
Set the SQL control to MIN.
Press POWER to turn the receiver on.
Turn VOL to adjust the volume.
Press BAND repeatedly to choose a band.
With each press, the lowest frequency of the next
band will be displayed. Press repeatedly until the
display shows the lowest frequency of the band of
your choice.
Adjust the SQL control (see page 11).
Scanning will start.
When the receiver receives a signal, w will light
up and the receiver will go into scanning pause. When
the signal breaks off, the receiver will resume
scanning automatically.
To turn off the power
Press POWER.
Frequency range of the bands
Frequencyrange
(MHz)
25.0 ~ 29.0
29.0 ~ 54.0
54.0 ~ 72.0
72.0 ~ 76.0
76.0 ~ 88.0
88.0 ~ 108.0
108.0 ~ 137.0
137.0 ~ 148.0
148.0 ~ 174.0
174.0 ~ 216.0
216.0 ~ 225.0
225.0 ~ 400.0
400.0 ~ 470.0
470.0 ~ 512.0
512.0 ~ 806.0
806.0 ~ 1000.0
(excluding cellularphone
1000.0 ~ 1300.0
(AM: Amplitude Modulation. NFM: Narrow Band Frequency
Modulation. WFM Wide Band Frequency Modulation)
10
Step
5kHz
5kHz
50kHz
5kHz
50kHz
100kHz
12.5kHz
5kHz
5kHz
50kHz
5kHz
12.5kHz
12.5kHz
12.5kHz
50kHz
12.5kHz
band)
12.5kHz
Detection
AM
N F M
WFM
NFM
WFM
WFM
AM
NFM
NFM
WFM
NFM
AM
NFM
NFM
WFM
NFM
NFM
Mode