Erasing Preset Memory - Sony ICF-SC1 Operating Instructions (primary manual) Operating Instructions Manual

Notes
*If you recall a page or a preset channel when you are in the
Scanning Mode, the receiver goes into the Manual Mode and the
*If a page number or a preset channel number is left flashing for 5
seconds or longer, the number will be entered (without having to
press EXE).
*If you change the frequency by tuning manually (i.e. by pressing
+/- ) after you have recalled a station, or if you change the
frequency step or the detection mode of the frequency, the preset
number indication will disappear in the display.
*If you recall an unoccupied channel, "- - -.- - -" will appear for
the frequency display and the sound will go out.
*If you recall a page with no occupied channels, "- - -.- - -" will
appear for the frequency display momentarily, and then the
receiver will return to previous status.

Erasing preset memory

To erase a channel preset
1
Recall the preset channel you want to erase.
2 Press ERASE until the frequency display changes to
" - - - . - - - "
The channel preset has been erased and the display
returns to Manual Tuning (without the preset
number).
Notes
*You cannot erase a channel preset in the Scanning Mode.
*You cannot erase the priority channel preset while receiving a
priority channel with Priority Scanning.
*You cannot retrieve a preset memory you have erased. Make
sure of the channel you are erasing.
To erase all preset memory at once
1
Press EXE, -, and PRESET simultaneously.
"dEL ALL PRESET" will flash in the display.
Hold the buttons down for 3 seconds or longer.
The flashing will stop and all the preset memory will
be erased.
Notes
*You cannot retrieve preset memory you have erased. Make sure
of the channels you are erasing.
*This operation will also revert the Intelligent Memory contents to
the factory preset.
2 5