Step 3: Adjusting The Picture Position - Sony Bravia VPL-VW200 Operating Instructions Manual

Step 3: Adjusting the Picture Position

Project an image on the screen and then adjust the picture position.
Remote control detector
Tip
? 1 (ON/STANDBY), INPUT, LENS, MENU, and M/m/</,/
The /
side panel of the projector function the same as those on the remote control.
Note
Depending on the installation location of the projector, you may not control it with the remote
control. In this case, point the remote control to the screen instead of the projector.
22
5,6,7
Lights in red.
Flashes in green for
a few seconds, and
then lights in green.
1
ON/STANDBY indicator
(joystick) buttons on the
1
Plug the power plug into the wall
outlet.
The ON/STANDBY indicator lights
in red and the projector goes into
standby mode.
2
Press the / (ON/STANDBY)
? 1
switch to turn on the projector.
The ON/STANDBY indicator flashes
in green, and then lights in green.
4
2