Installing The Projector; Connecting The Projector; Connecting To A Computer - Sony VPL-PS10 Operating Instructions Manual

Installing the Projector / Connecting the Projector

Installing the Projector

This section describes how to install the projector.
The distance between the lens and the screen varies
depending on the size of the screen. Use the following
table as a guide.
Distance between the screen
and the center of the lens
Screen
size
40 60 80 100
(inches)
Minimum
1.5 2.2 3.0 3.7
Distance
(4.8) (7.3) (9.8) (12.3) (14.8) (18.5) (22.3) (24.8) (31.0) (37.3)
Maximum
1.8 2.7 3.6 4.5
Distance
(5.8) (8.8) (11.8) (14.8) (17.8) (22.2) (26.7) (29.7) (37.2) (44.7)
For details, see "Installation Example" on page 34 (GB).
For details on ceiling installation, consult with qualified
Sony personnel (fee charged).
.........................................................................................................................................................................................................
1) DDC™ is a registered trademark of the Video Electronics Standards Association.
18
(GB)
Unit: m (feet)
120 150 180 200 250 300
4.5 5.6 6.8 7.5 9.4 11.3
5.4 6.8 8.1 9.1 11.3 13.6

Connecting the Projector

When making connections, be sure to do the
following:
• Turn off all equipment before making any
connections.
• Use the proper cables for each connection.
• Insert the cable plugs properly; plugs that are not
fully inserted often generate noise or cause picture
degradation. When pulling out a cable, be sure to
pull it out grasping the plug, not the cable itself.

Connecting to a Computer

This section describes how to connect the projector to
a computer.
For more information, refer to the computer's
instruction manual.
Notes
• The projector accepts VGA, SVGA, XGA, and
SXGA signals. However, we recommend that you
set the output mode of your computer to SVGA
(VPL-PS10) or XGA (VPL-PX15/PX10) mode for
the external monitor.
• If you set your computer, such as a notebook type, to
output the signal to both your computer's display and
an external monitor, the picture of the external
monitor may not appear properly. Set your computer
to output the signal to only the external monitor.
For details, refer to the operating instructions supplied
with your computer.
• The supplied mouse cable may not work properly
depending on your computer.
• This projector is compatible with DDC2B (Display
Data Channel 2B). If your computer is compatible
1)
with DDC , turn the projector on according to the
following procedures.
1
Connect the projector to the computer using the
supplied HD D-sub 15-pin cable.
2
Turn the projector on.
3
Start the computer.