Troubleshooting - Bissell ProHeat 7950 Series User Manual

Troubleshooting

Powerdrive does not seem to be engaged.
Possible Causes
The Powerdrive is in the OFF position.
1
Handle not fully engaged with Powerdrive position.
2
SmartTemp Ready Light does not illuminate.
Possible Causes
The SmartTemp Switch is not turned ON ( I ).
1
The machine Power Switch is not
2
turned ON ( I ).
Reduced spray or no spray.
Possible Cause
Bladder may be empty.
1
SmartMix Tank may be empty.
2
The filter may be clogged.
3
Tanks may not be seated properly.
4
Pump may have lost prime.
5
The Pump Belt may be broken.
6
20
ug310-5861_7950_205.indd 20 ug310-5861_7950_205.indd 20
Remedies
Turn the Powerdrive Knob to the "ON" Position.
1
Push handle in as far as it will go to feel the
2
most impact.
Remedies
Turn on the SmartTemp Switch.
1
Both switches must be ON ( I ) to
2
activate the SmartTemp Ready Light.
Remedies
Refill Bladder with hot tap water.
1
Fill with BISSELL Fiber Cleaning
2
Formula for cleaning or water if
rinsing, or using the Scotchgard
protector applicator.
Clean out Flow Indicator Filter, page 17.
3
Turn power OFF; remove & reseat
4
tanks. Inspect for presence of seals.
Turn power OFF; after 1 minute turn
5
ON and depress Trigger.
Turn the machine OFF and unplug
6
from the outlet. To check if a Pump
Belt has broken, you will need a flat
head screwdriver. Insert the blade end
into the lower slot of the Belt Access
door to release the lower snap. If
necessary, insert the blade end into
the upper slot to release the upper
snap. Examine the belt for breakage.
You should be able to see the Pump
Belt looped around the motor shaft. If
Lift Here
it is broken or missing, please refer to
Replacement Parts on page 23 before
calling Consumer Services. Complete
Insert installation instructions will
Screwdriver
accompany the replacement belt.
Blade Here
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
3/11/05 8:31:27 AM 3/11/05 8:31:27 AM