Troubleshooting (continued)
DirtLifter PowerBrush does not turn.
Possible Causes
The Brush Belt or Pump Belt is off or broken.
1
Carpet Protector is not spraying.
Possible Causes
Tank not connected properly to the tool.
1
Solution clogging the Spray trigger.
2
Applicator tool spray is blocked.
3
SmartMix not set on water/rinse
4
carpet protector setting.
ReadyTool dial not set on tool setting.
5
Cleaner not picking up solution.
Possible Cause
Ready Tools dial may be at the
1
wrong setting for the cleaning job.
Nozzle Window may not be properly attached.
2
Tank-in-Tank lid is not properly installed.
3
Tank-in-Tank is not properly seated.
4
Poor tool position. (Hand held attachments only).
5
Tank-in-Tank has picked up maximum dirty water.
6
If you should happen to need assistance during assembly or operations, call 1-800-237-7691.
ug310-5861_7950_205.indd 21
ug310-5861_7950_205.indd 21
Thank you for selecting a BISSELL product.
Please do not return this product to the store
Remedies
Turn the machine OFF and unplug from
1
the outlet. To check if the Brush Belt or Pump
Belt has broken, you will need a flat head
screwdriver. Insert the blade end into the
lower slot of the Belt Access door to release
the lower snap. If necessary, insert the blade
end into the upper slot to release the upper
snap. Examine the belt for breakage. If broken
refer to pages 18-19.
Remedies
1
Follow instructions on cartridge
assuring proper fit.
Soak applicator tool only in hot water.
2
Spray without the cartridge attached to
purge any residual Solution left in the tool.
Soak applicator tool only in hot water.
3
Spray without the cartridge attached to purge
any residual Solution left in the tool.
Set to proper setting.
4
Set to tool setting.
5
Remedies
Set ReadyTools dial to either Tools or
1
PreTreat or Floor Cleaning.
Press down firmly on the black oval gasket at
2
the top window to make sure the two tabs on
the back of the Nozzle Window are snapped
into the mating slots in the main housing.
Re-install lid; refer to page 8.
3
Tank-In-Tank must be firmly seated to
4
function; remove and reseat Tank-in-Tank.
Adjust angle; apply more downward pressure.
5
Empty Tank-in-Tank, refer page 8
6
21
3/11/05 8:31:27 AM
3/11/05 8:31:27 AM