HP-00007-01, Appendix 3
POWER SUPPLY PRINTED CIRCUIT ASSEMBLY cont
7
Remove the screws that secure the printed circuit assembly to the power supply chassis
(see Figure 18 below), and then lift the PCA out of the chassis.
NOTE: Screw quantity and location may vary.
POWER SUPPLY FAN
1
Remove the four screws that secure the fan to the power supply (see Figure 19 below).
2
Lift the fan out of the power supply.
3.2
ILLUSTRATIONS
FIGURE 1: Removing the computer cover
FIGURE 3: Disconnecting the drive and power
cables from the system board
FIGURE 2: Removing the fan shroud
FIGURE 4: Removing the security clip
HP Restricted
18-Aug-2005
Page 4