Troubleshooting; If Trouble Occurs - Sony DPP-FP35 Operating Instructions Manual

Troubleshooting

If trouble occurs

If you run into any problems using the printer, use the following guidance to solve
the problem. If the problem persists, consult your Sony dealer.
Power
Symptom Check
The 1 (on/ • Is the AC power cord
standby) switch
cannot be turned
on.
Connecting with a digital camera
Symptom Check
• Is the digital camera
The
PICTBRIDGE
indicator of the
• Is the printer turned on?
printer does not
light.
• Does the firmware of your
• Is the PICTBRIDGE
• Is printing in process?
• Is the printer connected to
34 GB
properly connected?
connected correctly?
digital camera support the
printer?
indicator of the printer
flashing?
the PC?
Cause/Solutions
c Connect the AC power cord to an AC
outlet securely. (.page 16)
Cause/Solutions
c Connect the cable correctly.
c Press the 1 (on/standby) switch to turn
on the 1 (on/standby) indicator in
yellow green.
c See the homepage for the digital camera
you are using.
c If a USB mouse or other non-PictBridge-
compliant device is connected, remove it
and connect a PictBridge-compliant device.
c Disconnect the digital camera and the
printer and then connect them again. Or
turn off and then on the printer and the
digital camera.
c Connect the cable again after printing is
complete.
c You cannot connect a PictBridge-
compliant digital camera and the PC to
the printer at the same time. Remove the
USB cable of the PC and connect the
digital camera again to the printer.