Installing A Disk Drive Or Solid-State Drive With The Power Turned On In Linux - IBM Power System 5148-22L Manual

Figure 35. Installing an SSD in an expanded function system
20. On the console, press Enter to indicate that you installed the drive.
21. If you are installing more than one drive, repeat the steps in this procedure until all drives are
installed.
Preparing the 5148-21L, 5148-22L, 8247-21L, 8247-22L, 8284-21A, or 8284-22A
system for operation after installing a disk drive or solid-state drive with the power
turned on in Linux
Learn to prepare the system for operation after you install a disk drive or solid-state drive (SSD) in the
system with the Linux operating system or Linux logical partition that controls the drive location
powered on.
To prepare the system for operation, complete the following steps:
1. Press Enter on the Complete Device Concurrent Add display to indicate that the disk drive or
solid-state drive is installed. The service indicator stops flashing and turns off for that drive slot.
2. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is
connected to an unpainted metal surface. If not, do so now.
3. On the front of the system, verify that the power LED is ON (green) for the installed or replaced
drive.
4. If applicable, cover the SSD cage with the perforated plate (A) as shown in Figure 36 on page 37.
36
Disk drives or solid-state drives
A