Input Channel Section - Zoom LiveTrak L-20R Operation Manual

Input channel section

Phase indicator
1
Input signal
2
EQ display
3
EFX 1/2 send
4
faders
Pan fader
5
REC/PLAY
6
button
MUTE button
7
SOLO button
8
Fader level
9
Channel fader
!
Level meter
"
Channel name
#
1 Phase indicator
Tapping the PHASE button in the channel strip will light this indicator.
2 Input signal
This indicator shows the signal level after adjustment by the GAIN knob.
The indicator color changes according to the signal level. Adjust so that it does not light red.
Lit red: input signal level is close (−3 dBFS or higher) to the clipping level (0 dBFS)
Lit green: input signal level is between −48 and −3 dBFS compared to the clipping level (0 dBFS)
3 EQ display
This shows the equalizer curve for the channel.
This to open the channel strip (→
4 EFX 1/2 send faders
The amount that can be sent to the SEND EFX 1 and 2 buses can be set from −∞ to +10 dB.
5 Pan fader
This adjusts the position in the stereo output bus.
On a stereo input channel, this adjusts the volume balance between the left and right channels.
NOTE
Double-tap a pan fader to reset it to its default value.
6 REC/PLAY button
Use this button to switch between recording input signals to the SD card and playing back an already
"Channel strip" on page
16
26).
Effect type
$
name
Effect
%
parameter 1
Effect
%
parameter 2
Effect return
&
fader