Fujitsu fi-7800 Operator's Manual page 151

A supplementary procedure describing how to install the brake roller on the scanner is provided below.
a
Insert the right side of the brake roller shaft.
b
Attach the left side of the brake roller shaft.
c
Close the brake roller cover, and make sure that both ends of the cover are locked firmly.
7
Close the ADF.
For details, refer to How to Close the ADF (page
Be careful not to get your fingers caught when closing the ADF.
CAUTION
ATTENTION
● Do not close the ADF while the roller cover is open.
● Confirm that the brake roller is installed properly. When the brake roller is not installed properly, it
causes feeding errors such as paper jams.
8
Plug in the power cable and turn on the scanner.
For details, refer to How to Turn the Power ON (page
9
Reset the brake roller counter.
Use one of the following methods to reset the counter.
● Select [23: Show/Clear Counters] from [Main Menu] on the operator panel, then reset the counter.
For details, refer to Checking and Resetting the Counters (page
● Start up the Software Operation Panel and reset the counter.
For details, refer to Resetting the Sheet Counters (page
28).
19).
83).
218).
151
Replacing the Consumables