Preparing To Use Your Grill - USSC Irondale USG890 Assembly And Operating Instructions Manual

1. Open the pellet hopper lid and remove any objects in the hopper.
2. Plug the grill into a three-prong, grounded power source.
3. Press the power button to "ON".
4. Open the hopper lid and check to see that the auger is turning freely -approximately 2 rpm. DO NOT
TOUCH THE AUGER.
5. Place your fingers over the burnpot and feel the air movement from the combustion blower. Ignitor will
glow within 1 minute. DO NOT TOUCH THE IGNITOR
6. Press the Power Button to "OFF".
7. Before replacing the removed components, clean all the items with soap and water, then rinse and allow
to dry. Re-install components.

PREPARING TO USE YOUR GRILL

Important: You must season the grill before cooking any food on your grill for the first time. The unit must be
operated at maximum temperature for 1 hour with the lid closed. This allows any oil residue from the manufacturing
process to burn off and also allows the high temperature paint to cure.
Avoid placing any items on the unit during this period as the paint could be permanently damaged.
WARNING: Never leave the grill unattended while operating.
Disconnect the grill from its power source when not in use.
Initial Firing Procedure
WARNING: DO NOT TOUCH THE AUGER
-8-
(Searing Station (if equipped) i