Step 3 - Side Table - USSC Irondale USG890 Assembly And Operating Instructions Manual

STEP 2 - GRILL BODY AND PEDESTAL ASSEMBLY
THE ASSISTANCE OF A SECOND PERSON IS STRONGLY RECOMMENDED FOR THIS STEP

STEP 3 - SIDE TABLE

Attach the side table to the grill body with four (4)
1/4" - 20 x 3/4" bolts and four (4) 1/4" flat washers
STEP 4 - GRILL SURFACE, DRIP PAN, AND FLAME PLATE ASSEMBLY
Place flame plate in bottom of grill body. ENSURE FLAME PLATE IS LEVEL
WARNING: If flame plate is installed incorrectly the pellets may burn back into the
hopper, and/or the grill may smoke excessively during cook mode and may not maintain
set cooking temperature properly.
Place drip pan.
Place main grilling surface on grill mounting bracket. Align with searing station.
USG350 is not equipped with a searing station. Instead, a second grill surface is provided.
WARNING: Never leave the grill unattended while operating.
Disconnect the grill from its power source when not in use.
Attach main grill body to the assembled pedestal
with six (6) 1/4-20 x 3/4" bolts and six (6) 1/4" flat
washers. Fasten the bolts along bottom of grill
body into the rivet nuts already installed in the
pedestal pieces.