Tools And Materials Needed For Installation - USSC Irondale USG890 Assembly And Operating Instructions Manual

UNPACKING:
1. Remove the grill from the carton.
2. Remove all packing materials applied for shipping.
3. Remove and hold all parts and hardware.
4. Inspect for damage. Promptly inform USSC Grills at (423)750-2723 of damaged or missing parts.

TOOLS AND MATERIALS NEEDED FOR INSTALLATION

You will need one (1) #3 phillip screw driver for assembly and one (1) 5/8" socket/
wrench to install wheels. Use proper assembly technique. When installing bolts,
start all bolts first and then tighten sufficiently.
STEP 1 - BASE AND PEDESTAL ASSEMBLY
1. Attach the swivel wheels to base using four (4) 1/4"-20 x 1/2" bolts, four (4) 1/4"
lock washers, and four (4) 1/4" flat washers on each wheel.
2. To attach the fixed wheels to the axle, slide on two (2) 3/8" flat washers,
followed by one (1) wheel and one (1) 3/8" flat washer.
3. Secure the wheel to the axle with one (1) acorn nut. Repeat this step to attach
the second fixed wheel to the opposite end of the axle.
4. Assemble the pedestal using the provided six (1/4" - 20 x 3/4" bolts and six (6)
1/4" flat washers. Fasten the bolts to the threaded inserts.
5. Assemble the pedestal to the base using six (6) 1/4" - 20 x 3/4" bolts and six (6)
1/4" flat washers.
6. Tighten all fasteners
WARNING: Never leave the grill unattended while operating.
Disconnect the grill from its power source when not in use.
Assembly Instructions
Wheel Installation
Pedestal and Base Assembly
change image to show assy sequence:
Nut, washer, wheel, washer (1), axle
-6-
Parts List
Description Qty
Pedestal, Right Side 1
Pedestal, Left Side 1
Pedestal, Center 1
Base 1
Caster Wheel 2
Fixed Wheel 2
1/4-20 Bolt x 3/4" 22
Acorn Nut 2
1/4" - 20 X 1/2" Bolt 8
Side Table 1
1/4" Flat Washer 30
1/4" Lock Washer 8
3/8" Flat Washer 4