Tools And Materials Needed For Installation - USSC Irondale Assembly And Operating Instructions Manual

READ ALL INSTRUCTIONS BEFORE INSTALLING AND USING THE APPLIANCE

TOOLS AND MATERIALS NEEDED FOR INSTALLATION

• #3 phillip screwdriver (use of a drill with a phillips bit will speed up the assembly process)
Use proper assembly technique when installing bolts, start all bolts first and then tighten appropriately. The
assistance of a second person is strongly recommended.
STEP 1 BASE AND PEDESTAL ASSEMBLY
1. Swivel Wheel Installation
• Attach both swivel wheels, one at a time; to the
grill base using the provided bolts, lock washers,
and flat washers.
2. Fixed Wheels Installation
• Slide the axle through the hole located in the
front side flange of the grill base.
• Secure the axle to the grill base using the
provided washer, lock washer, and nut.
• Slide the wheel onto the axle and secure into
place using the provided washer, lock washer,
and hex head screw.
• Repeat these steps to attach the second fixed
wheel to the other side of the unit.
Assembly Instructions
Remove the grill contents for assembly.
ATTENTION: The assistance of a second person is
strongly recommended for this step.
-5-
3. Assembling the Pedestal
• Attach the left and right pedestal panel to
the center pedestal panel using the provided
washers and bolts.
4. Attaching the Pedestal
• Attach the assembled pedestal to the base
using the provided washers and bolts.
5. Attaching the Main Body
• Attach the main grill body to the assembled
pedestal with the provided washers and bolts.