Replace Drive Belt - Bissell 82G7 SERIES User Manual

ntenance and care
Replace drive belt
.
2.
Unplug the vacuum from electrical outlet.
With the rotating floor brush removed
from the vacuum cleaner (Steps 1-4 of
check rotating floor brush and drive
belt onpage 12), grasp the old drive
belt andremove from the motor pulley.
Discard the old drive belt.
.
.
.
Place the new drive belt over the motor
pulley and loop other end over the
rotating floor brush in the space between
the bristles.
NOTE: It is important that you use
only genuine BISSELL replacement
belts. Generic belts may not meet
the exact specifications required
to keep your vacuum operating
at its peak performance. The use
of unbranded belts could lead to
early failure of the vacuum and
could void your warranty.
Pull the rotatin_l floor brush firmly into
position, stretching the drive belt and
place ends of the rotatinG floor brush
down into the slots on sides. Alignment
of brush ends in slots may be necessary
to fully insert the brush.
Turn the rotating floor brush by hand sev-
eral times. If properly installed, the drive
belt will center itself on the rotating brush
crown.
6. Insert front edge of brush cover, rotate
into place, and snap 3 latches.
Replace li_lhtbulb
1. Unplug the vacuum from electrical outlet.
2. Using a flat head screwdriver, pry the
tab on the left and right side out and
pull out to remove the lens.
3. Remove the bulb from the socket by
grasping the bulb and pulling gently.
Install the new bulb by pushing it gently
into the socket until the bulb snaps into
place.
4.. Reposition the lens and snap it back
into place.
Motor
Pulley
Pulley
2.
3.
www. b i s se II. co m _n_, 800.237.7691