Cn Ser And; For Pc Or Controller - Panasonic MINAS A Series Operating Manual

CN SER and CN NET Connectors (For PC or Controller)
・ These connectors can be used as either RS232C or RS485. There are three
ways for using these connectors as shown below.
For RS232C communication only
Connect the personal computer and the driver 1:1 through RS-232C,The
PANATERM using for communication control softwere. The PANATERM using this
function the monitor of the personal computre settings wave graphics.
How to connect
ロータリスイッチ（ID）は1（出荷設定）でご使用ください。
For both RS232C and RS485 communication
You connect the host and the 1st driver with RS232C, and connect the drivers
in series with RS485.
ID MODE SET
IM SP G
I/F
ロータリスイッチ（ID）を1〜Fに設定してください。
For RS485 communication only
Connect all the drivers and a host with RS485.
・ Rotary switch (ID): select a position 1 to F.
＜ Note ＞
・ Max. 15 drivers can be connected to a host.
・ For detailed information, see Communication Specifications.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Special
cable (optional)
ID MODE SET
IM SP G
I/F
CN SER
RS485
ID
RS232C connector
(rear)
RS485
MODE SET ID MODE
IM SP G IM SP
I/F
RS485 connector
（CN NET）
− 27 −
Turn off the power of both the
driver and computer, before
connecting or disconnecting
the connectors.
Tighten the screws firmly.
Host (personal computer
or controller)
SET
G
RS232C
I/F
232C/485 connector
（CN SER）
ロータリスイッチ（ID）
は0に設定する。