Handling The Main Machine - Ricoh Aficio SP 8200DN Operating Instructions Manual

Hide thumbs Also See for Aficio SP 8200DN:
Table of Contents

Advertisement

Handling the Main Machine

R WARNING:
• Turn off the power and disconnect the power plug (by pulling the plug,
not the cable) if any of the following occurs:
• You spill something into the machine.
• You suspect that your machine needs service or repair.
• The external housing of your machine has been damaged.
R CAUTION:
• Unplug the power cord from the wall outlet before you move the machine.
While moving the machine, you should take care that the power cord will
not be damaged under the machine.
• For environmental reasons, do not dispose of the machine or expended
supply waste at household waste collection points. Disposal can take place
at an authorized dealer.
• Before moving the machine, unplug the power cord from the wall outlet. If
the cord is unplugged abruptly, it could become damaged. Damaged plugs
or cords can cause an electrical or fire hazard.
• When moving the printer after use, do not take out toner and development
unit to prevent toner spill inside the machine.
• When moving the machine, hold the handles at both sides, and then lift the
printer slowly. Lifting it carelessly or dropping it may cause an injury.
• After you move the machine, use the caster fixture to fix it in place. Other-
wise the machine might move or come down to cause an injury.
• Contact your service representative if you need to lift the machine (such as
when relocating it to another floor). Do not attempt to lift the machine with-
out the assistance of your service representative. The machine will be dam-
aged if it topples or is dropped, resulting in malfunction and risk of injury to
users. The machine's various handling areas are for service engineer use
only. Do not touch these areas.
• Do not allow paper clips, staples, or other small metallic objects to fall inside
the machine.
• Do not look into the lamp. It can damage your eyes.
Important
❒ Rating voltage of the connector for options: Max. DC 24 V.
❒ Voltage must not fluctuate more than 10%.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents