Table of Contents
Advertisement
Step 4: Apply DSP
With firmware 4.x and higher, the MXA910 includes IntelliMix DSP that can be applied to the automix channel output.
AEC, noise reduction, and automatic gain control (AGC) are on by default.
1.
To use AEC, route a far-end reference signal to the microphone's AEC Reference In channel.
◦
Use Designer to route a reference signal coming from a Shure device, like the ANIUSB-MATRIX or P300.
◦
Use Dante Controller to route a reference signal from other third-party Dante devices.
2.
Select IntelliMix, and click AEC.
3.
Verify that the far-end signal is present on the reference meter. If it doesn't show up, check the routing.
4.
To apply any other DSP blocks or edit settings, click the block icon.
Shure Incorporated
10/59
Hide quick links:
Advertisement
Table of Contents
