Checking Chain Lubrication; Adjusting The Telescoping Shaft - Stihl HTA 65 Instruction Manual

English
Place the cap on the opening and
N
rotate it counterclockwise until it
engages the filler neck.
Continue rotating the cap
N
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
Turn the cap clockwise and lock it in
N
position – see section on "Closing".
14

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your machine without
chain lubrication. If the chain runs dry,
the whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
Adjusting the Telescoping
Shaft
Only version with telescoping shaft
WARNING
Always switch off the power tool and
move the retaining latch to ƒ.
180°
1
Open lever (1) of quick-release
N
clamp and swing it back as far as it
will go.
HTA 65, HTA 85