Setup / Change Connection Pc - Emulation System; Setup Serial Connection; Overview; Settings - Fujitsu MB91460 Getting Started

Chapter 7 Setup / Change Connection PC – Emulation System
7 Setup / Change Connection PC – Emulation System
This chapter describes who to establish the connection between PC and emulation system.
The emulator MB2198-01 offers three possibilities to program and to debug a device,
namely via
- Serial connection
- USB
- LAN
In the template for the 91V460 all three connection types are already preconfigured, but for
some device additional settings have to be made.

7.1 Setup Serial Connection

7.1.1 Overview

The emulator MB2198-01 offers the possibility to program and debug a device via a serial
connection. Even though this is a very easy to install connection, the transmission speed is
very slow.

7.1.2 Settings

The default setting for debugging via a serial connection is COM 1 and a baud rate of
115200 Baud.

7.2 Setup USB

7.2.1 Overview
The emulator MB2198-01 is provided with a USB port that can be used to program and
debug a device. No additional hardware connection is required for this purpose

7.2.2 Updating the USB-Drivers

To operate the emulator MB2198-01 on the PC, the USB-Drivers of the PC have to be
updated. The following procedure describes the update-process.
1. Connect the USB-Cable to the emulator MB2198-01 and to the PC. Connect the 16 V
DC power supply to the port 'DC in' and to 230 V. Please, be aware, that the
emulator is switched off. Also refer to Figure 2.
2. After the PC is booted, power up the emulator. Windows will register a new hardware
component and will start the hardware wizard. Select the option 'No, not this time' to
search the drivers manually and press 'Next'.
MCU-AN-391005-E-V17
Getting Started
- 32 - © Fujitsu Microelectronics Europe GmbH