Executing The Program; Ending The Debugging; Last Steps - Fujitsu MB91460 Getting Started

Getting Started
Chapter 6 Softune Workbench Getting Started
Figure 18: Debugging Mode after a successful Connection
Note that the interface has to be determined only once. Later you can choose the menu
Debug/Start debug to enter this mode.

6.7 Executing the Program

Now choose Debug/Run/Go, press F5 or click the button. Look at the Starter Kit. A
"scrolling" LED has to be flashing on the Board.
To halt the execution, choose Debug/Abort or click the button (Note, that this button is
only active in execution mode). The emulator system now is being halted. The execution can
be continued by entering the "Go"-Mode again.

6.8 Ending the Debugging

To end the debugging just choose the menu Debug/End debug.

6.9 Last steps

To save the project data choose File/Close Workspace.
Click "Yes". Afterwards you can close the Softune Workbench.
Note, that in the next start of the Workbench, your new LED-Project will occur in the menu
list File/Recent Workspace File. By simply clicking to "Led.wsp", the whole project will open
again.
© Fujitsu Microelectronics Europe GmbH - 31 - MCU-AN-391005-E-V17