Power Led; Led Bar - NETGEAR Orbi Pro Ceiling Satellite User Manual

6. Reset button.
page 28.
7. Sync button.
on page 14.

Power LED

The Power LED is located to the left of the LED bar on the top panel. The following table
describes the behavior for the Power LED bar.
Table 1. Power LED behavior
Color LED behavior
Solid green Power is on. This is the normal Power LED behavior when the satellite is on.
Blinking amber A firmware upgrade is in progress or the satellite is resetting to factory default settings.
Solid red PoE power is not at the 802.3at (PoE+) level, which is required if you use a PoE connection. For
more information, see You use PoE power and the Power LED is solid red on page 34.
Blinking red The firmware is corrupted. For more information, see The Power LED is blinking red on page
34.
Off Power is not supplied.

LED Bar

The LED bar is located to the right of the Power LED on the top panel. The following
tables describe the behavior for the LED bar.
Table 2. LED bar behavior
Color LED behavior
Pulsing white The satellite is booting.
Pulsing white after you The satellite is trying to sync with the Orbi Pro router. The LED might pulse white for
press the Sync button about six minutes. After the LED pluses white, it lights blue, amber, or magenta. See the
next table for more information.
Solid white The satellite is ready to sync with the Orbi Pro router.
After you press the Sync button, the LED bar pulses white. Then, for about three minutes,
the LED bar lights one of colors described in the following table. After three minutes,
the LED bar turns off.
Overview
Orbi Pro Ceiling Satellite
For more information, see Reset the satellite to factory defaults on
For more information, see Sync your satellite using the Sync button
9 User Manual