Half-Rack Size Diversity Tuner (Urx-R1) - Sony UWP-C1, UWP-C2, UWP-C3 Operating Instructions Manual

9 OUTPUT (audio output)
connector (3.5-mm diameter stereo
mini jack)
Connect one end of the supplied XLR-
BMP conversion cable or the stereo
mini plug-BMP conversion cable here
and the other end to the microphone
input on a camcorder, mixer, or
amplifier. If the microphone input
connector on the device connected to
the tuner is a stereo mini jack, connect
the straight (BMP) plug to the tuner
and the L-shaped (stereo mini) plug to
the microphone input connector on the
device.
Half-rack size diversity
tuner (URX-R1)
Front panel
Rear panel
1 POWER switch
Turns the power of the tuner ON or
OFF.
2 Antennas a/b
The angle of the antennas can be
adjusted manually.
3 MONITOR connector (phone
jack)
To monitor the tuner output, connect
the headphones to this connector and
adjust the monitor level with the
MONITOR control. Use either stereo
or monaural headphones.
4 MONITOR control
Turn to adjust the output monitoring
level (through the headphones).
5 + (+ selection) / – (– selection/
reset) buttons
Press these buttons to set the reception
channel and frequency.
6 Display section
A B
RF
AF
A RF (radio frequency) indications
The number of dots indicates the RF
input level.
CH
C
35