Connection Via Gatekeeper - Sony PCS-1 System Integration Manual

3-4. Connection via Gatekeeper

Example of system
LAN1
192.100.10.1
Teleconference Gatekeeper
terminal A 192.100.10.20
192.100.10.10
User name:
PCS1A
User number:
100
When a call is initiated from teleconference terminal A to teleconference terminal B.
1. The LAN set menu of teleconference terminal B is set as described below.
DHCP mode:
Host name:
IP address:
Network mask:
Gateway address:
DNS address:
Gatekeeper used:
Gatekeeper address:
User name:
User number:
SNMP service:
Trap transmission destination: Blank
Community name:
Description of device:
Installation place:
Contact of administrator:
NAT setting:
NAT address:
Packet retransmission request: Blank
Optimum rate control:
Port number used:
TCP port number:
UDP port number:
2. Confirm that the IP address displayed in the launcher menu of teleconference terminal B is
192.100.20.20.
3. Confirm that Registration Confirm is displayed at the bottom of page 2/5 in the LAN set menu of
teleconference terminal B.
PCS-1/PCS-1P
Router Router
OFF
Enter any name.
Local IP address (192.100.20.20)
Depends on a network. Usually, set to 255.255.255.0.
192.100.20.1
Blank
ON
192.100.10.20
Enter any name. (Example: PCS1B)
Enter any number. (Example: 200)
OFF
public
Videoconference Device
Blank
Blank
OFF
Blank
OFF (Set to ON when a packet loss occurs frequently.)
Specified value (Set to "User setting" when a port number is specified
by the network administrator.)
2253 (Enter the port number specified by the network administrator
when the port number used is set to "User setting".)
49152 (Enter the port number specified by the network administrator
when the port number used is set to "User setting".)
LAN2
192.100.20.1
Teleconference
terminal B
192.100.20.20
User name:
PCS1B
User number:
200
3-7