Sony PCS-1 System Integration Manual page 60

For loading of application
1. Display a service menu.
2. Insert the Memory Stick, in which the application
software of the version to be loaded is recorded, into a
Memory Stick slot.
3. Select "Load application" using , ,
buttons of a remote controller and press the decide
button.
4. A confirmation message on whether to execute is
displayed.
5. To execute, select "OK" and press the decide button.
The screen display during loader execution then
appears. After completion, a launcher menu is
displayed. To cancel execution, select "Cancel" and
press the decide button. The current display returns to
a service menu.
6. Push in the Memory Stick once and take out it.
n
Do not turn off the power or take out a Memory Stick until
the launcher menu is displayed.
For command input
1. Display a service menu.
2. Select "Command" using , ,
remote controller and press the decide button.
A key guidance is then displayed.
3. Enter the commands in a command list from a remote
controller.
m
. To set two or more commands, put a one-character
blank between the commands and then enter them.
. Set only one type of LAN interface. If not, the LAN
interface does not operate normally.
4. Select "Save" using , ,
remote controller and press the decide button.
A set menu is then displayed.
5. When a LAN interface is set (including the case where
the setting is returned to the initial value), restart the
main unit using the power switch of a communication
terminal.
To stop setting
Select "Cancel" using , ,
controller and press the decide button, or press the return
button of a remote controller.
n
Do not enter commands other than shown in a command
list. The internal operation mode may be changed in this
case.
2-30
, and
, and buttons of a
, and buttons of a
, and buttons of a remote
Contents of functions
1) Commands
The internal operation mode of the main unit is
changed for a test and service.
Command list
Command
100F Sets a LAN interface to the 100BASE
full-duplex mode.
100H Sets a LAN interface to the 100BASE
half-duplex mode.
10F Sets a LAN interface to the 10BASE full-
duplex mode.
10H Sets a LAN interface to the 10BASE
half-duplex mode.
TOS1 to Sets the Type Of Service (TOS) bit value
TOS255 to a transmission packet.
Consult the network administrator for
the set value.
Blank (The Set using an initial value.
input value The LAN interface mode is Auto
above is Negotiation.
cleared.) Reception packet loss indicator
display ON
TOS0
m
. To set two or more commands, put a one-character blank
between the commands.
. Set only one type of LAN interface. If not, the LAN
interface does not operate normally.
. The enabled command can be confirmed in a command
column at all times.
. Do not enter commands other than shown in a command
list. The internal operation mode may be changed in this
case.
Contents
PCS-1/PCS-1P