Sony UWP-C1 Specification Sheet page 11

SPECIFICAIONS
Bodypack Transmitter
Oscillator Crystal-controlled PLL synthesizer
Type of emissionF F3E
Carrier frequencies
AU model 792 MHz to 806 MHz (TV channels 66 to 67), Users may choose from 102 frequencies.
CE model 798 MHz to 822 MHz (TV channels 62 to 64) or 838 MHz to 862 MHz (TV channels 67 to 69)
Users may choose from 189 frequencies on each model.
U model 758 MH to 782 MHz (TV channels 62 to 65) or 782 MHz to 806 MHz (TV channels 66 to 69)
Users may choose from 188 frequencies on each model.
RF power output 30 mW or 5 mW (selectable)
λ wave length wire
Antenna 1/4
Pilot tone signal 32 kHz
Frequency response 50 Hz to 18 kHz (typical)
Reference deviation ±5 kHz (-60 dBV, 1kHz input)
Signal-to-noise ratio 60 dB or more (±5 kHz deviation at 1 kHz modulation, A-weighted)
Microphone capsule –
Audio attenuator adjustment range 0 to 21 dB (in 3 dB steps)
Audio input level -60 dBV (at 0 dB attenuator level)
Audio input connector 3.5 mm (5/32 inch) dia., 3-pole mini jack
Max. input sound pressure level –
Indicators
LCD Operating channel number/frequency, attenuator level, RF-output level (High/Low), audio input status
transmitter battery status, and accumulated operating time
LED Power status
Power requirements DC 3.0 V (with two AA-size alkaline (LR6) batteries)
Battery life Approx. 6 hours with Sony AA-size alkaline (LR6) batteries at 25 °C (77 °F) at 30 mW output
Dimensions (W x H x D) 63 x 100 x 27 mm (2 1/2 x 4 x 1 1/8 inches)
Mass Approx. 140 g (4.9 oz) including batteries
Supplied accessories Omni-directional (UWP-C1)/Uni-directional
(UWP-S1/X1)lavalier microphone (x1),windscreen (x1),
microphone-holder clip (x1), belt clip (x1)
Handheld Microphone
30 mW or 5 mW (selectable)
1/4 λ wave length wire (internal)
100 Hz to 18 kHz (typical)
±5 kHz (94 dB SPL, 1kHz input)
Dynamic capsule (uni-directional)
–
–
151 dB SPL (at 21 dB attenuator level)
φ52 x 240 mm (φ21/8 x 9 1/2 inches)
Approx. 300 g (10.6 oz) including batteries
Microphone holder (x1)
Plug-on Transmitter
–
50 mW
Integral type
50 Hz to 18 kHz (typical)
±10 kHz (-60 dBV, 1kHz input)
60 dB or more (±10 kHz deviation at
1 kHz modulation, A-weighted)
–
MIC input position: -60 dBV (at 0 dB
attenuator level), LINE input position: +4 dBu
XLR-3-11C type
–
Operating channel number/frequency, attenuator-
level, audio input status, RF-output status, transmitter
battery status, and accumulated operating time
Audio-input status
Approx. 6 hours with Sony AA-size alkaline
(LR6) batteries at 25 °C (77 °F) at 50 mW output
44 x 99 x 36 mm (1 3/4 x 4 x 1 7/16 inches)
Approx. 185 g (6.5 oz) including batteries
Soft case (x1)
11