Pre-Treating; Deep Cleaning; Getting Ready - Bissell 1672 SERIES User Manual

How To Deep Clean Carpet

Getting Ready

Remove dry filter bag from ball cage.
1.
Remove concentrate measuring cup from filling cavity on
2.
side of tank unit.
Pour two gallons of hot tap water (temperature should
3.
not exceed 120° F/48° C) into filling cavity until level
reaches bottom of three vertical lines in tank unit.
Shake bottle of BISSELL Carpet Care. Fill measuring lid to
4.
fill line (10 ounces). Empty measuring lid into filling cavity
and replace measuring lid.
Plug power cord into approved grounded outlet.
5.

Pre-treating

Pre-treat highly soiled areas: Press on pump/spray
1.
switch, hold floor nozzle 4" - 6" above soiled carpet, and
pull trigger to spray cleaning solution.
Wait 5-10 minutes. Scrub tough stains with floor nozzle
2.
brush.

Deep Cleaning

Turn on pump/spray and vacuum/suction switches. Place
1.
floor nozzle directly on carpet at arm's length. Pull trigger
to spray cleaning solution while pulling wand toward you.
Repeat, keeping floor nozzle firmly against carpet
2.
surface. Continue until no more dirt can be removed.
Do not overwet.
Release spray trigger. Vacuum area until no more
3.
cleaning solution can be removed.
Continue to clean entire carpet, working in 3' x 4' sections.
4.
If the machine loses suction, stops spraying and/or motor
5.
noise rises in pitch, empty the tank [see WHEN YOU'RE
DONE, page 9]. Failure to empty tank will damage unit.
If floor nozzle stops spraying, turn off pump immediately
6.
and check cleaning solution level. Never run pump dry.
8
Measuring
Remove Measuring Cup
From Filling Cavity
Tip:
Use only BIS-
SELL Carpet
Care in this
appliance. Use
of cleaning for-
mulas which
contain lemon
or pine oil may
damage this
appliance and
void warranty.
Vacuum/suction switch
Tip:
Deep cleaning
stairs and high
Pump/spray switch
traffic areas on
a regular basis
can prolong
carpet life.
Cup
Filling Cavity